Modify the settings for Wired Network.Click the Control tab at the top and then select Network Configuration.If the icon is orange, click connect and enter username admin and password 123456. Orange means you are connected but not logged in.
Green means you are connected and logged in.Confirm that the player is listed and verify the activity status icon on the left.Open Viplex Express, select Async and select the terminal tab.Connect to the network and enter the password 12345678.Stand very close to the sign and search for the WIFI network called AP# (AP followed by a series of numbers).And have a laptop with Viplex Express installed. To access this network, you must be very close to the sign. Still unable to connect? If the settings above do not work, connect to the sign's backup network to check the network configurations.To attempt this route, contact us to schedule your session. Finally, the Access Point can also be reconfigured as a repeater to extend your Network to the sign.In other cases, we must reconfigure the Access point and Client to match your network settings An alternative option is to connect the LAN Port to your router.Leave the remaining fields blank then, select Ok, and then close.Now, select 'Use the following IP address, then enter the following IP address: 10.1.10.127.Right-click on your Ethernet Adapter and select properties.Select Network and sharing center and then change adapter options.Connect the computer to the Signcity network, then proceed to the next step.To maintain the best connection, position the Access point and Client within the line of sight of each device. Three (3) lights indicate that you have an excellent connection to the access point.The three lights above display the signal strength. You may notice that the LAN light intermittently flashes. The first two lights, Power and Lan, should be constantly lit.You can verify that you have a good connection by looking at the lights on the Client. Wait for the access point to power on, and all the lights are lit.
To power the Access point, plug the ethernet cable into the POE port on the POE injection.
Your next step is scheduling your training session we will help you navigate this new world. Things are about to get exciting now that your LED Sign is powered on.